![simplify 3d outline underspeed simplify 3d outline underspeed](https://live.staticflickr.com/320/19282702213_0d945b05d0_c.jpg)
The Ultimaker 2 comes with a fairly flat glass bed that is attached to the heated plate through metal clips on the corners. In addition to the leveled bed, the method of increasing surface stickiness is important as well. Heated Bed and Print AdhesionĪ properly leveled bed is mandatory for good quality prints. All prints were made using white 3mm ABS filament from on an Ultimaker 2. In order to provide high quality examples, I am using my custom fan mount along with my custom filament extruder. Both the printer and print bed are properly leveled.There are no major quality issues with your prints in terms of over/underextrusion, top-fill, etc.Your printer works and can print with satisfactory results.Specifically I’ll assume that you have meet the following prerequisites: Rather than re-addressing the topics covered in introductory guides, I’ll assume that readers of this guide have read and followed the tips and tricks in IRobertI’s guide and have a decently working printer. Problem within prints are often caused by a combination of issues rather than having a single contributing source of error. Detailed macro photographs are provided to back my observations and also serve as a comprehensive visual aid.
![simplify 3d outline underspeed simplify 3d outline underspeed](https://ars.els-cdn.com/content/image/1-s2.0-S0926580520311092-gr5.jpg)
![simplify 3d outline underspeed simplify 3d outline underspeed](https://i.imgur.com/Wsq4W4s.png)
All of the following notes and tips are derived solely from my experiences. Most of the information in this guide however can also be applied to other 3D printers. To address this, I’ve decided to write up a fairly comprehensive troubleshooting and optimization guide tailored for the Ultimaker 2 with Simplif圓D (v2.2.2) as the slicing engine. While there are some very good guides out there (see IRobertI’s guide in particular), many of these guides don’t go beyond the basics for calibrating a 3D printer. Getting a perfect 3D print is notoriously difficult, even with a fairly expensive top-of-the-line consumer printer such as the Ultimaker 2. Please reference Simplif圓D’s troubleshooting guide instead. My Simplif圓D profile can be found here while calibration STLs can be downloaded here THIS GUIDE IS NOW OUTDATED WITH THE RELEASE OF SIMPLIFY3D v3.0. This is NOT a guide for those who are new at 3D printing!